Grinding a flexographic printing drum over 2 m at its working temperature
A flexographic printing drum more than 2 metres in diameter and length expands when it is working. If it is ground cold, its geometry changes once it reaches the machine. With a MARSE temperature control unit the drum is ground at its working temperature, with the material already expanded.
- Drum
- > 2 min diameter and length
- Thermal expansion of steel
- ≈ 12 µmper metre and per °C
- Example Ø 2 m
- ≈ 120 µmwith a 5 °C difference
- Control
- Heating and cooling PIDwith auto-tuning

The case at a glance
- Workpiece
- Flexographic printing drum more than 2 m in diameter and length.
- Aim
- Grinding with the material expanded, at working temperature.
- Equipment
- MARSE temperature control unit with fluid circulating inside the drum.
- Because
- Steel expands ≈ 12 µm per metre and per °C.
The process and the initial problem
A flexographic printing drum is manufactured with straightness, cylindricity and concentricity tolerances in the order of microns. But the drum does not work at room temperature: in the press it is at its process temperature and the steel expands.
If it is ground cold, the workshop delivers a geometry that is no longer valid once it heats up. The solution is to grind it under the same conditions in which it will work: with the fluid circulating inside it at working temperature.
In the workshop and in production
The same temperature in both places: the grinding accuracy is preserved on the machine.
- The fluid circulates inside the drum
- The drum is kept at its working temperature
- The geometry is measured and corrected under these conditions

- The drum, mounted in the flexographic press
- The temperature control unit maintains the same temperature
- The ground geometry is preserved in production
How much the drum expands: an indicative calculation
Expansion of the diameter of a steel drum:
Theoretical calculation with a steel expansion coefficient of 12·10⁻⁶ /°C. Actual values depend on material and temperature.
Why a MARSE temperature control unit in this case
For the process engineer
- The geometry is measured and corrected at the actual working temperature.
- Heating and cooling PID control with auto-tuning: stable temperature throughout the grinding.
- Same temperature in the workshop and on the machine: what is ground is what works.
- Temperature graphs to document the grinding conditions.
For the maintenance manager
- Repeatable measurements, independent of the workshop temperature.
- The fluid circulates inside the drum: uniform heating with no external elements.
- The same type of unit serves on the grinding machine and in the machine room.
Technical keys
- Grinding expandedThe drum is ground with its actual expansion.
- Microns matter5 °C on a 2 m drum is ≈ 120 µm in diameter.
- Workshop and machine, the sameThe same temperature in both places.
- Internal heatingFluid inside the drum, evenly.
Result
Frequently asked questions
Why grind a drum at its working temperature?
Because steel expands with temperature: if it is ground cold, the drum changes geometry when it heats up in the machine.
How much does a 2-metre drum expand?
With steel, about 24 µm in diameter per degree; a 5 °C difference means about 120 µm.
How is the drum heated during grinding?
A MARSE temperature control unit circulates the fluid inside it at working temperature.
Equipment and technology
Other success stories

Cleanroom reactors without exceeding their maximum pressure
View case →
Jacketed reactors of up to 2,000 l with 3 bar jackets
View case →